Test-certified axle group compliant with ECE R13.11 regulation, equipped with SAF brand disc brakes.
Each axle has a capacity of 3×9 tons.
3rd axle is self-steering, 1st and 2nd axles are fixed.

6+1 units of 385/65 R 22.5 tires.
11.75×22.5 rims.
Compliant with 92/23/EEC and 2005/11/EC standards.

Flexible and high-strength I-section chassis manufactured by cutting and bending ST52 quality steel plates and joining them using MAG gas-shielded and submerged arc welding methods.
120×14 mm flat bar, 8 mm mirror plates at front and rear.

Superstructure compliant with 97/27/EC and 2003/19/EC directives.
Robust grid structure reinforced by welding high-strength steel profiles.
Floor: 3 mm ST52 bent sheet.
Transport combination: 1×40 ft, 2×20 ft and 1×20 ft containers.
On both sides, 2×6 lashing posts with a total height of 600 mm from the floor, with recessed sockets underneath.

Brake system compliant with ECE R13.11 regulation.
Roll Stability Support (RSS), 4S-3M sensor configuration, EBS brake system.
24-type service brake chamber on the 1st axle.
Spring-applied diaphragm-supported 30×30 emergency brake chambers on the 2nd and 3rd axles.
Automatic slack adjuster.
Electromagnetic compatibility compliant with ECE R10.03 regulation (radio interference suppression).
Air suspension system with shock absorbers preventing excessive axle movements.

ADR-compliant LED electrical system with 1×15 pin socket in accordance with ECE R48.04 regulation.
24-volt lighting system.
Side lamps, stop lamps, 2 license plate lamps and reverse lamp.
Reflective markings and license plate holder compliant with 70/222/EEC directive.

Locally manufactured mechanical support legs with 24-ton lifting capacity, two-speed, single-side operated.

2-inch king pin compliant with ECE R55.01 regulation.

2 projection lamps at rear.
2×5 vertical stakes on each side (600 mm length).
Wide storage compartment for wooden boards.
2×5 manual winches with 10 m cables on the sides, 2 manual winches with 15 m cables at the rear.
Cable holders along the trailer.
Lashing hooks with 12 mm thickness and 25 mm inner diameter, 5+5 ro-ro rings on right and left sides.
3 license plate holders for bumper and ADR.
Rear impact block.
1 spare wheel carrier with locking system.
2 steel toolboxes, chassis-mounted water tank.
Fire extinguisher cabinet.
Reflectors, 2 wheel chocks and holders.
Audible warning device at rear.
Axle hub cap removal wrench.
Small document box, lamp guards.
Rear underrun protection bumper compliant with ECE R58.02 regulation.
Side protection devices compliant with ECE R73.01 regulation.
Mudguards compliant with 91/226/EEC and 2010/19/EC directives.
Top cover for air and electrical connections.

After sandblasting to SA 2 1/2 quality, epoxy primer and topcoat paint are applied according to requested RAL color codes.
(Average primer + paint thickness: 120 microns)